Troubleshooting
-
Why the Voltage in a Short Circuit is Zero and Current is High
Why the Reactance and Voltage under Fault Condition is Low and Current is High Theoretically and ideally, the Voltage and Reactance of a system (under fault condition such as short…
Read More » -
Difference between Analog and Digital Multimeter
Main Differences between Digital and Analog Multimeter Both Digital Multimeter and Analog Multimeter (also know as multi-tester) are used to test and measure different electrical quantities such as Current in…
Read More » -
Main Difference Between Contactor and Starter
Difference Between Contactor and Motor Starter The magnetic starter is very similar to the magnetic contactor in both design and operation. Both devices operate by activating contacts when the coil…
Read More » -
Main Difference between Fuse and Circuit Breaker
What is the Difference between Fuse and Circuit Breaker A fuse is a device, which is used to protect circuits from over current, overload and make sure the protection of the circuit. It…
Read More » -
Soldering Iron Temperature Controller
Soldering Iron Temperature Controller Circuit & Working If you are an electronic enthusiast, then you must be familiar with soldering iron device. This is generally used to design electronic circuits…
Read More » -
How To Perform a Continuity Test for Electrical Components with Multimeter?
What Is Continuity Test & How To Test for Continuity? Continuity Test For Different Electrical & Electronic Components & Devices In Electronics & Electrical systems, electrical wiring installations, maintenance, troubleshooting…
Read More » -
How to Test a Relay? Checking SSR & Coil Relays
How To Test A Relay Using Multimeter & Battery? Its Terminal Identification & Operation In this article, we will show you “how to test a relay“. A relay usually gets…
Read More » -
Which Bulb Glows Brighter When Connected in Series and Parallel & Why?
Two Bulbs of 80w and 100w are Connected in Series and Parallel. Which One Will Glow Brighter and Why? The most frequently asked and confusing question we receive is: If…
Read More » -
Failures In Electrical Systems, Equipments & Materials
Failures In Electrical Systems, Causes & Prevention Introduction Electrical systems, equipments and materials are subjected to failures that can cause the total destruction of equipments and severe power outages. For…
Read More » -
Electrical Installations – Standards & Regulation around the World
Electrical Installations – Standards & Regulation in Different Countries Introduction The construction and the characteristics, performances and tests to be carried out on HV, MV and LV (HV: High Voltage;…
Read More »
